Introduction
.
-
-
Locate the Power On button.
-
Press the Power On button.
-
Wait for the machine to initialize.
-
-
-
The screen will display an error warning (similar to that shown) upon initializing and the light will flash red.
-
Make sure the Emergency Stop is pulled out.
-
The display will flash alarm warnings on the bottom of the screen.
-
Locate the Reset button.
-
Press Reset button until the alarms are cleared.
-
-
-
The screen may display the message "Cycle Door."
-
Open the machine door.
-
Close the machine door.
-
The message will go away.
-
-
-
Now the machine must be zeroed.
-
Find the "Power Up/Restart" button.
-
Press the "Power Up/Restart" button.
-
Wait for the machine to zero the axes.
-
-
-
The display may now read "Manual Mode."
-
If it does, follow the instructions at the bottom of the screen, "Write" to activate manual control of axes.
-
The machine is now started, you have completed this guide.
-