-
-
Place “Indicol” dial indicator holder on spindle nose
-
-
-
Place spindle in neutral gear.
-
-
-
Set indicator to swing a 9” circle (Full Y table width or tram ring diameter)
-
-
-
Set X axis first
-
Set a zero position in the X axis
-
Swing indicator 180 degrees in the X axis, note difference on indicator
-
-
-
Loosen the four ¾” bolts, and snug them
-
Using geared worm shaft, adjust as necessary
-
Re-torque the four bolts to 50 ft lbs
-
-
-
Repeat for the Y axis
-
(Note: the table is designed to be approximately .0005” high the front)
-
Loosen and snug three ¾” bolts
-
Using geared worm shaft adjust to .0005” high in front, zero in rear
-
Re-torque bolts to 50 ft. lbs.
-
Almost done!
Finish Line