-
-
Hose down the machine
-
Make sure the coolant valves on the inside of the machine are off
-
Make sure a tool/holder is in the spindle so no coolant enters spindle
-
Turn on the COOLNT
-
Make sure the valve on the hose (at rear of machine) is turned on
-
Bring the hose around to the front or side of the machine
-
Spray, making sure chips are cleared off fixture and machine elements and forced into the trough below
-
-
-
OPTIONAL
-
Press CHIP FWD to grind the chips
-
Run for 5-10 seconds
-
Press CHIP STOP to end the grinding
-
Remove the tool from the spindle when finished flushing chips
-
-
-
Use the hand jog to center the weight of the table/vise on x and y axes to ensure weight balance on the ways
-
-
-
Find the "Emergency Stop" button.
-
Push in the "Emergency Stop" button.
-
The screen will now display an alarm and the light will flash red, this is normal.
-
-
-
Find the "Power Off" button.
-
Press the "Power Off" button.
-
The machine will power down.
-
Pull out the Emergency Stop button so that the machine is ready to be turned back on.
-
