-
-
Use a 2.5mm hex key to remove the four (4) top-plate fasteners from the recoater.
-
Remove the old top-plate from the recoater.
-
-
-
Use a 2.0mm hex key to adjust the set screws that govern the distance between the recoater and the top-plate.
-
Use the new top-plate to verify all set screws are equally raised.
-
Install the top-plate using the 2.5mm hex key to tighten the (4) top-plate fasteners.
-
-
-
The front powder chute-facing side of the recoater has no bolts along the logo panel's cut-outs.
-
The sloped edges of the top-plate must be on the front powder chute facing side of the recoater.
-
-
-
Do not move the recoater carriage forward or backward if the build platform is raised above the chamber floor. Doing so while the recoater is installed may damage the carriage motor.
-
Use the "Front" command on the Manual Control tab in the MSC to bring the empty recoater carriage forward.
-
Use the TX25x89 bit to fasten the recoater carriage with the six (6) torx head bolts . [INFO ON BOLTS]
-
-
-
Use the "Back" command on the Manual Control tab in the MSC to return the carriage to the powder chute.
-
The gap between the top-plate and the powder chute silicone ring must be at least 100 microns thick.
-
Standard printer paper is ~100 microns thick and may be used to verify the correct gap distance.
-
Both powder chute cams must be in complete contact with the top plate.
-
Almost done!
Finish Line